KUHL 10 Hole Rear Roll Out Nest
Open Gallery Modal
KUHL 10 Hole Rear Roll Out Nest
KUHL 10 Hole Rear Roll Out Nest
KUHL 10 Hole Rear Roll Out Nest
KUHL 10 Hole Rear Roll Out Nest
DSPC210

KUHL 10 Hole Rear Roll Out Nest

1 Review
$749.95
QTY

Free Shipping

Free shipping applies to most orders over $150 sent standard ground service within the lower 48 states. Custom items not shown in this catalog along with items marked with "Does not qualify for free shipping" are excluded from the free shipping offer. Items excluded from the offer are subject to change without notice. Due to the ever-rising cost of outbound shipping, any order with backordered item(s) may be held until the backordered item(s) arrives.

FREE Shipping on Most Orders Over $150*

Product Details

Description

This nest is designed for those desiring to collect eggs from aisles in between the pens. The nests can be mounted on the wall, the hens enter from the front and the eggs roll out the back. The back is hinged so the collector can push in for inspection, plus the back of the nest is blocked so the hen can’t go out. Complete with plastic roll out bottoms. 60” W x 34” H x 12” D. Rivet gun required for assembly, not included.

Note: This product is drop-shipped directly from the manufacturer. Please allow approximately 4-6 weeks for delivery.

Specification

  • 0.00 LBS

Frequently Bought Together

Reviews

1 Review
Write a Review
  • 1

    Kuhl 10 square nesting box.

    by Kinda on Sep 15, 2025

    Goes together with OP RIVETS. WHO the heck has a pop rivet gun? Made of CHEAP aluminum that bends like a wet noodle when you pick it up. Pieces were bent up upon opening the box. Your directions were horrible, pictures were even worse! when I googled to the item to reference, your page describes this unit as a rear egg roll out, and shows a picture of it set up that way. Your directions are just the oposite, it goes together as a front roll out. Oh and the hanging brackets....You have to put those on before riveting it together..other wise the rivet is in the location the braket should screwed into.